Take-A-Label

Model 750HD Operating Instructions

NOTE: The TAKE-A-LABEL dispenser is shipped mounted to a base to prevent shifting in the container. Remove the machine from the base. Always load the TAKE-A-LABEL dispenser with the On-Off Switch (3) in the (OFF) position.

  1. To load a roll of labels on the TAKE-A-LABEL, slide the roll of labels over the spinndle using the blade to grip the core of the roll of labels.
  2. Place a roll of labels on the unwind shaft so that the beginning of the roll is on the bottom of the web coming off to your right as you face the side of the machine.
  3. Thread loose end of labels under and up the front of the stripping plate.
  4. Pull labels over top of stripping plate far enough to reach the waist take-up roll.
  5. Remove the waist wind clip, thread label backing paper under clip, and reinsert clip over loose paper.
    spring clip
  6. Position the photo cell switch by loosening thumb screws and moving the assembly to right or left so that the photo cell is at or near the center of the labels. The photo cell switch can be tilted forward or backward by loosening the mounting bracket vertical adjustment wing nut.
  7. Turn on On-Off switch. The waist wind shaft will turn, winding up backing paper and exposing a label at the top of the stripping plate. When the photo cell sees tgeh dispensed portion of the label, the motor will stop. As each label is removed, the machine will operate until the next lable is in position to be removed. (CAUTION:) Turn off switch before removing wound up waist.
  8. If labels tend to follow backing paper over the top of the stripping plate instead of peeling off and lifting the label switch trip wire, there is probably insufficient tension on the web of the labels. The unwind tension adjustment collar should be moved in to put more tension on the web.
  9. If the motor stalls it may be necessary to reduce the tension. Unwind the Tension Knob to reduce pressure on the spring.label feeding chart