- Rotate forward both plastic knobs on side of load and lock bar to
unlock.
- Pull plastic knobs until in full forward position.
- Set rolls for tape and/or labels on base rollers so adhesive side
faces down.
|
 |
| Tape: Pull end of roll about 5" forward. |
Label: Pull end of roll about 10" forward
over bottom metal bars. |
- Install roll separators between rolls.
- Push back the plastic knobs on load and lock bar into their original
position and lock.
|
 |
Now ready to use.
Tape: Pull end to the cutting bridge. |
Label: Pull end forward slowly to dispense
label from liner. |
