Marsh ESC60 Stencil Express Cutter Total Solution
Everything You Need to Start Stenciling Upon Receipt!
The Marsh ESC60 is an electronic, computer driven stencil cutting system. Achieve varying stencil requirements with ease on your computer. The Windows-OS based software is designed to run directly from an existing PC and does not require a stand-alone dedicated system. Software is supported on these systems: Windows XP, Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10.
If you just need the ESC60 without the total solution, click here.
Have you ever cut a long stencil message and on the 75th letter, punched the wrong letter? Then you have to start all over and try again. Not with the ESC60 electronic stencil cutter! Type in your messages, verify, then cut. You also have the ability to save for future use.
The stand is included with the machine.
The ESC60 Total Solution includes:
- The MSSC ESC60 electronic stencil cutter with stand
- Two 100 foot rolls of .011 oil board
- One roll of Express-Cut Polyethylene Film .008
- Two 60 degree blades
- A RFR200-30 Refillable Fountain Roller 3" with a quart of Black RolMark Stencil Ink
- A quart of 180C-RMS-Q RolMark Ink Solvent And Cleaner
If you need K-Stencil Ink, we will substitute for the RolMark Ink. (Special note: International orders will only be filled with K-Stencil Ink due to shipping restrictions.)
| || |
The Express(Ultra)-cut material sticks to surfaces giving you a much cleaner print and works great on curves.
Set up your whole message, check spelling, then hit the print button. Note the various fonts and sizes from the same machine.
This (above) is using the Express-Cut Polyethylene Film .008.
This (above) is using .011 Oilboard on a roll. You get a little smudge but the stencils should last longer.
Limited manufacturers warranty parts and labor at the factory.
Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries.