1 1/2" Refillable Fountain Roller with Black RolMark Ink

Your Price: $94.95

Retail Price:$120.19

You Save:$25.24(21%)

Part Number: 180M-RFR200-15BK

Quantity

The pump action of Marsh Fountain Roller gives you fast, uniform ink dispensing without fading or flooding.

1 1/2" (3.8 cm) roller width with RolMark Ink for use on porous or non-porous surfaces.

RolMark ink must be shipped via ground. For expedited delivery options, please call our office - (770) 554-1187.

For full pdf instructions, and a schematic, click here.

Inking

Fill the Fountain Roller handle with the proper ink. We offer Marsh Rolmark and K Stencil.
Pump roller 30 to 50 strokes while rolling back and forth on stencil board. (Do not use an absorbent material.) For uniform distribution of ink, apply extra pressure and use an inking path of at least 12".
To test for uniformity, make a test roll on a clean carton using normal rolling pressure.

Pass the roller back and forth over the stencil with straight passes. If one side of the roller inks too heavily, turn it over.
When more ink is needed, pump once or twice before or while stenciling.

To correct unequal distribution of ink, roll on a test surface applying extra pressure.
Do not allow the roller to dry.
During continuous stenciling, occasionally pump ink to prevent drying.
When not in use, use the roller cover to protect the foam rubber.

Remove the screw and then the roller.
Wipe spindle and cover the orifice with an absorbent cloth.
Fill the reservoir 1/4 full with the proper solvent: Rolmark Solvent (if using Rolmark Inks) or K Stencil Solvent (if using K Stencil Inks).
Shake vigorously; then empty the reservoir.
Refill the reservoir 1/4 with solvent. Keep orifice covered with an absorbent cloth. Flush roller by pumping.
Drain all the solvent, lubricate seals and bearing with light machine oil, reinstall roller and refill with proper ink.

Remove the screw and then the roller
Remove the O-Rings with a pointed tool; be careful not to damage the bearing surface.
Install the new O-Rings
Lubricate the O-Rings and bearings with light machine oil and reinstall the roller.

$14.09